The Ashly Audio NXE Series NXE4004BD 4-channel networkable multi-mode power amplifier comes pre-installed with OPDAC4 internal 4-channel DAC with selectable HPF and OPDante Dante network audio interface cards. The OPDante card enables access to digital audio networks at low latencies (83.3 µs) over fast Ethernet. It can be installed in the rear card slot of NXE series amplifiers. Signal can be routed from other Dante enabled devices by simply connecting a Cat5e or Cat6 cable to the card's primary or secondary (redundant) Ethernet ports. The amplifier is capable of driving 2 Ohms loads at full power and offers a maximum rated output power of 400W per channel at Low Z and 70V, and 100V modes. In addition, the amplifier is suitable for use in performance venues, stadiums, arenas, convention centers as well as schools, store fronts, and places of worship.
The amplifier comes with Neutrik XLR/TRS combo jack and Euroblock input connectors and Neutrik speakON output connectors. The unit features a front panel power switch and level controls that can be disabled. The LEDs indicate Protect, Sleep, Disabled, Com, and Bridge mode status, as well as Temperature, Output Current, Output Signal, and Clipping/Mute status per channel. In addition, the power amplifier features an Ethernet control with a real-time clock for event scheduling. The power amplifier is equipped with serial data remote control, aux preamp outputs, preset control, and fault condition logic outputs. It also features a temperature dependent variable speed forced-air cooling. In addition, the amplifier can be mounted on a standard 19" rack.
Features- Ethernet control using Protea NE software
- Serial data control by Ashly programmable remotes or third party controllers
- Aux preamp outputs, instant standby mode, preset recall, fault condition logic outputs, and optional CobraNet or AES3 digital audio capability
- Real-time clock with event scheduler
- Assign automatic execution of selected functions and tasks
- Event scheduler is programmed using PneS software and stored in the amplifier
- Ashly remote control via iPad app for custom design of secure wireless control over a network
- Features a switch-mode power supply that automatically detects 120 or 240 VAC operation
- Selectable outputs on each channel allow you to choose the desired output mode
- Set the DIP-switch configuration for low impedance (2, 4, and 8 Ohms), or constant voltage (70V or 100V)
Specifications- Signal-to-Noise Ratio: 20 Hz to 20 kHz, Unweighted: >105 dB
- Frequency Response: 20 Hz to 20 kHz, +/-0.05 dB
- Input Connector Balanced: Euroblock 3.5 mm, 1/4" TRS and XLR combo jack
- Input Impedance: 10 kOhms
- Maximum Input Level: +21 dBu
- Supported Data Connections: Euroblock 3.5 mm - Gnd, +18 V, In, Out
- Environmental: 32 to 113 deg F (0 to 45 deg C) (non-condensing)
- Dimensions: 19" x 3.5" x 16.84"
- Weight: 28.7 lbs
