NX Multi-Mode Power Amplifiers are designed to meet the most demanding live sound environments and fixed audio installations anywhere - performance venues, stadiums, arenas, convention centers as well as schools, store fronts, and worship spaces.
The Ashly nXe4002 is a 2 channel multi-mode power amplifier capable of driving 2 Ohm loads at full Power. The maximum rated output power is 400W per channel at Low Z, 70V, and 100V mode.
Features- Selectable 80Hz Hipass filter, limiter, and input gain per channel, via rear panel
- Remote DC level control per channel
- Extensive protection circuitry, continuously variable cooling fans
- Ethernet port for software control and monitoring of amplifier functions, with front panel COM activity LED
- Serial data port for Ashly WR-5 and RD-8C programmable remote control (optional RS-232 converter INA-1 for third party controllers)
- Instant Standby Mode, 30% reduction in idle power Consumption, triggered by contact closure, software control, or event scheduler
- Preset recall via contact closure, software control, remote control, or event scheduler
- Programmable Power-on delay
- Aux preamp line outputs for driving other amplifiers
- Fault condition logic outputs, per channel
Specifications- Voltage Gain: Selectable at 26dB, 32dB, 38dB, or 1.4V
- Damping Factor: Greater than 250 (8 Ohm load Input High Pass Filter: 80Hz 2nd order
- Distortion (SMPTE, typical): Distortion (THD-N, typical)
- Channel Separation: -75dB (dB from full output, 1kHz)
- Signal-to-Noise (20Hz - 20kHz, unweighted): Greater than 105dB (all 400x models)
- Frequency Response: 20Hz - 20kHz, -0.05dB
- Balanced Input Connector: Euroblock 3.5 mm, 1/4" TRS and XLR Combo jack
- Input Impedance: 10k Ohm
- Maximum Input Level: +21dBu
- Speaker Output Connector: Neutrik; speakON
- Control Network: Compatible with standard 100MB Ethernet
- AUX Output Connector: Balanced Euroblock 3.5 mm
- AUX Output Maximum Level: +21dBu
- Remote Standby Contact Closure: Euroblock 3.5mm, close contact to GND for standby mode
- Preset Recall Contact Closure: Euroblock 3.5mm, close contact to GND for preset 1-4 recall
- Data Connection: Euroblock 3.5mm - Gnd, +18V, In, Out
- Fault Condition Logic Outputs: Fault Indicated by Loss of 1Hz "Heartbeat" Pulse Signal
- Remote DC Level Control: Euroblock 3.5mm - Gnd, CV, V+ per input
- Attenuators (per channel): Front panel, software, offset link group, and remote. Fully off = Mute
- Amplifier Protection: Inrush current limitation, temperature monitoring, output over-power protection, mains fuses
- Cooling: Continuously variable temperature controlled axial fan(s)
- Environmental: 32 deg F - 113 deg F, (0 deg C - 45 deg C) (noncondensing)
- Nominal (Automatic Sensing SMPS): 110 - 120VAC; 220 - 240VAC
- Operating Range: 70 - 135VAC; 140 - 270VAC
- Minimum Power-Up: 85VAC; 170VAC
- Power Cable Connector: 20A powerCON
- Dimension: 19" x 3.5" x 16.84"
- Weight: 28.7 lbs
